Fujitsu D1859 technical manual Keyboard error nn nn Stuck Key

Page 39

Error messages

Keyboard error nn nn Stuck Key

Release the key on the keyboard (nn is the hexadecimal code for the key).

Missing or invalid NVRAM token

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Monitor type does not match CMOS - RUN SETUP

Correct the entry for the monitor type in the Main menu of the BIOS Setup. On Board PCI VGA not configured for Bus Master

In the BIOS Setup, in the Advanced menu, submenu PCI Configuration, set the Shared PCI Master Assignment entry to VGA.

One or more RDRAM devices are not used

One or more RDRAM devices have bad architecture/timing

One or more RDRAM devices are disabled

Contact your system administrator or contact our customer service centre.

Operating system not found

Check the entries for the hard disk drive and the floppy disk drive in the Main menu and the entries for Boot Sequence submenu of the BIOS Setup.

Parity Check 1

Parity Check 2

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Previous boot incomplete - Default configuration used

By pressing function key F2 you can check and correct the settings in BIOS Setup. By pressing function key F1 the system starts with incomplete system configuration. If the message is still displayed, please contact your sales outlet or customer service centre.

Real time clock error

Call the BIOS Setup and enter the correct time in the Main menu. If the message is still displayed, please contact your sales outlet or customer service centre.

System battery is dead - Replace and run SETUP

Replace the lithium battery on the system board and redo the settings in the BIOS Setup.

System Cache Error - Cache disabled

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

System CMOS checksum bad - Default configuration used

Call the BIOS Setup and correct the previously made entries or set the default entries.

D1859 (Econel 50)

33

Image 39
Contents English Reliability2Are there Page Page Contents Page System board D1859 Notational conventionsAdditional information Information about boards Important notesInternal ports List of featuresOnboard features Special onboard featuresExternal ports Brief instructions on installing system board Prior to installationInstallation Driver installation Interfaces and connectors External ports LAN connectorHard disk connection Internal ports and connectorsPin assignment of internal ports Front panelSerial ATA IDE/ATA interface Fan USB dual channelFloppy interface Intrusion LCD displayAdditional power supply ATX12 Power supply BTXPower supply control Recovering System Bios pinpair B Jumper settingsSetting via control-panel plug connector Skipping system and Bios Setup password pinpair aAdd-on modules / Upgrading Installing and removing processorsInstalling processor with heat sink Technical dataAdd-on modules / Upgrading Mounting heat sink Upgrading main memory Removing a memory module Installing a memory moduleMonofunctional expansions cards Adding PCI Express cardsAdding PCI cards PCI bus interrupts Selecting correct PCI slotPCIe On board controllerUSB Slot PCI USB PCI Slot SMBusReplacing the lithium battery When should a Bios update be carried out? Bios updateBios Recovery Recovering System Bios Microcode Update What is a microcode update?When should a microcode update be carried out? System board Revision System board Revision and Bios VersionBios version AnnexLoadability for connections and fuses Electrical PropertiesBios update for installed CPU failed Error messagesIncorrect Drive a run Setup Incorrect Drive B run Setup Keyboard error nn nn Stuck Key System Management Configuration changed or Problem occurred Glossary Information on this document