IBM PC 300PL manual Super input/output controller, Diskette Drive interface, Seria l ports, Port

Page 18

Chapter 2 . System board features

ŸMicrophone for connecting a microphone.

Super input/output controller

Control oftheintegratedinput/output(I/O)and diskettedrivecontrollersisprovidedbya singlemodule. This module, whichsupportsPlug and Play,controlsthefollowingfeatures:

ŸDiskettedriveinterface

ŸSerial port

ŸParalle port

ŸKeyboardand mouse ports

ŸGeneral-purposeI/Oports

Diskette	drive interface
The PC 300PL	Personal Computer has fourdrivebaysforinstallinginternaldevices.The followingisa

listofdevicesthatthediskettedrivesubsystemsupports:

Ÿ1.44MB, 3.5-inchdiskettedrive

Ÿ1.44MB, 3.5-inch,3-mode driveforJapan(no BIOS supportfor3-mode drive)

Ÿ1.2MB, 5.25-inch diskettedrive

Ÿ1 Mbps, 500-Kbps, or 250 Kbps internaltapedrive

One connectorisprovidedon thesystemboardfordiskettedrivesupport. For informationon the connectorpin assignments, see“Diskettedriveconnector” page 31.

Seria l ports

Two universalasynchronousreceiver/transmitter(UART) serialportsareintegratedintothesystem board. The serialportsinclude16-bytedata,first-firstin-out(FIFO)buffersand have programmable baud

rategenerators.The serialportsareNS16450 and PC16550A

compatible.

For informationon theconnectorpin assignments, see“Serialportconnector” page 34.

Note : Current loop interfaceisnot supported.

The followingfigureshows theserialportassignments in theconfiguration.

Figure 4.	Serial port assignments

Port assignment		Address range (hex)	IRQ level

Serial1		03F8–03FF	IRQ4

Serial2		02F8–02FF	IRQ3

Serial3		03E8–03FF	IRQ4

Serial4		02E8–02FF	IRQ3

The defaultsettingfortheserialportisCOM1.

Paralle

l port

Integratedin thesystemboardissupportforextendedcapabilitiesport(ECP), enhancedparallelport (EPP), and standardparallelport(SPP) modes . The modes ofoperationareselectedthroughthe Configuration/SetupUtilityprogram withthedefaultmode settoSPP . The ECP and EPP modes are compliant withIEEE 1284.

The followingfigureshows theparallelportassignments usedin theconfiguration.

10 TechnicalInformationManual

Image 18

Contents Page Are 1999Apply WithContents System software BiosError codes PostReferences Index Contents Recovery jumper Power-input requirements USB port Internal DasdTerminology usage PrefaceRelated publications ViiEquals Bytes, and2 073 824Expressing storage Capacity Equals Major features System overviewSystem overview Network support Other featuresPOST/BIOS PCIOn Ring Features FeaturesSystem board features SystemSystem memory RimmPCI bus IDE bus master interfaceUSB interface Video subsystem BusVideo subsystem resources Interface Plug Play support Advanced PowerList Bus Mastering Support For Fast Performance 64-bit 125 Resource AssignmentFeatures Monitor supportAudio subsystem Seria l ports Super input/output controllerDiskette Drive interface PortKeyboard and mouse ports Network connectionRPL Expansion adapters System board features Real-timeFlash Eeprom Physical layoutSystem board, Types 6584 Riser card layoutsRecovery jumper Recovery jumperCable connectors DVIConnector panel System boardTypes 6584 and 6594. Physical specificationsThis Section Lists Physical Specifications For NICWake LAN adapters Have Pin Right-angle Header For TowerRequirements For AUX5Power output Power supplyPower input Power supplyComponent outputs Components draw less current than Maximum ShownConnector description Output protectionSystem software PlaySystem software Configuration/Setup Flash update utility programDiagnostic program UtilityHardware interrupts System compatibilityHardware compatibility System compatibilitySoftware interrupts Hard disk drives and controllerSoftware compatibility Machine-sensitive programsAppendix A. Connector pin assignments Appendix A. Connector pin assignmentsMonitor connector Monitor port connector pin assignments-SVGAPin Signal Memory connectorsSystem memory connector pin assignments Pin assignmentsPCI connector pin assignments Pin AssignmentsConnector PinThese Assignments Are For Connector slot One Only For All Other slots, the signalConnectors Are on Riser card For pin A41IDE connectors IDE connector pin assignmentsPower supply connector pin assignments ConnectorDiskette drive connector pin assignments Pin Signal nameConnector pin Alert on LAN connectorsTamper detection switch Radio frequency identification Rfid pin assignmentsPort CD audio connectorUSB port connectors KeyboardParallel port connector pin assignments Keyboard port connector pin assignmentsSerial port connector pin assignments ConnectorPin Signal Ground Input/output Appendix B. System address mapsSystem AppendixMaps O address mapHex Size Description Are ReservedDMA I/O address map Bits Byte PointerConfiguration MapSystem address maps IRQ channel assignments Appendix C. IRQ and DMA channel assignmentsAppendix C. IRQ and DMA channel assignments DMA channel assignmentsCodes Appendix D. Error codesAppendix D. Error Codes Beep codesAppendix E. Notices and trademarks References This PublicationReference Advanced Power SpecificationReferences Connector IndexIndex Features Wake on LAN 2 Wake on Ring MemoryRfid