IBM 2289, 6824 manual What to do next

Page 25

2.You might have to remove an adapter to gain access to the DIMM slots. See “Installing adapters” on page 14.

3.To locate the DIMM connectors. See “Identifying parts on the system board” on page 11.

4.Open the retaining clips.

5.Make sure the notches in the DIMM align with the tabs on the connector. Push or insert the DIMM straight down into the connector until the retaining clips close.

What to do next:

vReplace any adapters that were removed.

vTo work with another option, go to the appropriate section.

vTo complete the installation, go to “Replacing the cover and connecting the cables” on page 21.

Chapter 1. Installing options 13

Image 25

Contents User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide To connect To disconnect Safety InformationModem safety information Lithium battery noticeConnexion Déconnexion Consignes de sécurité relatives au modem Laser compliance statementViii User Guide Information resources OverviewUser Guide Features Installing optionsAudio subsystem Security features Specifications Tools required Available optionsHandling static-sensitive devices Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector DescriptionRemoving the cover Identifying parts on the system board Locating componentsInstalling memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Physical security Connecting an additional IDE CD-ROM drive or DVD-ROM driveChanging the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Starting the IBM Setup Utility program Using the IBM Setup Utility programViewing and changing settings Exiting from the IBM Setup Utility programAdministrator password User passwordSetting, changing, and deleting a password Using Security Profile by DeviceSelecting a temporary startup device Selecting a startup deviceChanging the startup device sequence User Guide Updating flashing Bios from your operating system Updating flashing Bios from a disketteAppendix A. Updating System Programs System programsRecovering from a POST/BIOS update failure Basic AT commands Appendix B. Manual modem commandsExtended AT commands Enable RTS/CTS hardware flow control Guard tone disabledUS setting for off-hook-to-on-hook ratio Force DSR Signal High onFax Class 1 commands MNP/V.42/V.42bis/V.44 commandsFax Class 2 commands Voice commands User Guide System memory map Appendix C. System address mapsAddress map Address range Address range hex Size Description DecimalLPT3 Address hex Description Bits Byte pointer DMA I/O address mapAddress hex Description Bits Byte pointer DMA channel Data width System resource System resourceUser Guide Television output notice Appendix E. NoticesIBM TrademarksDVD IndexPage Page Part Number 49P1040