IBM 2289, 6824 manual Selecting a startup device, Selecting a temporary startup device

Page 39

Selecting a startup device

If your computer does not start up (boot) from a device such as the CD-ROM, diskette, or hard disk as expected, use one of the following procedures to select a startup device.

Selecting a temporary startup device

Use this procedure to startup from any boot device.

Note: Not all CDs, hard disks, and diskettes are startable (bootable).

1.Turn off your computer.

2.Turn on your computer and look for the following prompt on the logo screen:

(To interrupt normal startup, press Enter)

Press Enter when you see the prompt.

3.When the Startup Interrupt Menu displays, press F12.

4.Select the desired startup device from the Startup Device menu and press Enter to begin.

Note: Selecting a startup device from the Startup Device menu does not permanently change the startup sequence.

Changing the startup device sequence

To view or permanently change the configured startup device sequence, do the following:

1.Start the IBM Setup Utility program (see “Starting the IBM Setup Utility program” on page 25).

2.Select Startup.

3.Select Startup Sequence. See the information displayed on the right side of the screen.

4.Select the devices for the Primary Startup Sequence, the Automatic Startup Sequence, and the Error Startup Sequence.

5.Select Exit from the IBM Setup Utility menu and then Save Settings.

If you have changed these settings and want to return to the default settings, select Load Default Settings on the Exit menu.

Chapter 2. Using the IBM Setup Utility program 27

Image 39

Contents User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide To connect To disconnect Safety InformationLithium battery notice Modem safety informationConnexion Déconnexion Consignes de sécurité relatives au modem Laser compliance statementViii User Guide Information resources OverviewUser Guide Features Installing optionsAudio subsystem Security features Specifications Available options Tools requiredHandling static-sensitive devices Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector DescriptionRemoving the cover Identifying parts on the system board Locating componentsInstalling memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Physical security Connecting an additional IDE CD-ROM drive or DVD-ROM driveChanging the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Exiting from the IBM Setup Utility program Using the IBM Setup Utility programStarting the IBM Setup Utility program Viewing and changing settingsUsing Security Profile by Device User passwordAdministrator password Setting, changing, and deleting a passwordSelecting a startup device Selecting a temporary startup deviceChanging the startup device sequence User Guide System programs Updating flashing Bios from a disketteUpdating flashing Bios from your operating system Appendix A. Updating System ProgramsRecovering from a POST/BIOS update failure Basic AT commands Appendix B. Manual modem commandsExtended AT commands Force DSR Signal High on Guard tone disabledEnable RTS/CTS hardware flow control US setting for off-hook-to-on-hook ratioMNP/V.42/V.42bis/V.44 commands Fax Class 1 commandsFax Class 2 commands Voice commands User Guide Address range Address range hex Size Description Decimal Appendix C. System address mapsSystem memory map Address mapLPT3 Address hex Description Bits Byte pointer DMA I/O address mapAddress hex Description Bits Byte pointer DMA channel Data width System resource System resourceUser Guide Television output notice Appendix E. NoticesIBM TrademarksDVD IndexPage Page Part Number 49P1040