IBM 6824, 2289 manual Connecting the first IDE CD-ROM drive or DVD-ROM drive

Page 30

6.Install the drive into the bay. Align the screw holes and install two screws to secure the drive.

7.Each integrated drive electronics (IDE) drive requires two cables; a four-wire power cable that connects to the power supply and a signal cable that connects to the system board. For a CD-ROM drive, you might also have an audio cable.

The steps to connect an IDE drive are different depending on the type of drive you are connecting. Use one of the following procedures for your drive connection.

Connecting the first IDE CD-ROM drive or DVD-ROM drive

1.Locate the three-connector signal cable that comes with your computer or with the new drive.

2.Locate the secondary IDE connector on the system board. See “Identifying parts on the system board” on page 11.

3.Connect one end of the signal cable to the drive and the other to the secondary IDE connector on the system board. To reduce electronic noise, use the connectors at the end of the cable only.

4.Your computer has extra power connectors for additional drives. Connect a power connector to the drive.

18User Guide

Image 30

Contents User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide Safety Information To connect To disconnectLithium battery notice Modem safety informationConnexion Déconnexion Laser compliance statement Consignes de sécurité relatives au modemViii User Guide Overview Information resourcesUser Guide Installing options FeaturesAudio subsystem Security features Specifications Available options Tools requiredHandling static-sensitive devices Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Connector Description Obtaining device driversRemoving the cover Locating components Identifying parts on the system boardInstalling memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Connecting an additional IDE CD-ROM drive or DVD-ROM drive Physical securityChanging the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Viewing and changing settings Using the IBM Setup Utility programStarting the IBM Setup Utility program Exiting from the IBM Setup Utility programSetting, changing, and deleting a password User passwordAdministrator password Using Security Profile by DeviceSelecting a startup device Selecting a temporary startup deviceChanging the startup device sequence User Guide Appendix A. Updating System Programs Updating flashing Bios from a disketteUpdating flashing Bios from your operating system System programsRecovering from a POST/BIOS update failure Appendix B. Manual modem commands Basic AT commandsExtended AT commands US setting for off-hook-to-on-hook ratio Guard tone disabledEnable RTS/CTS hardware flow control Force DSR Signal High onMNP/V.42/V.42bis/V.44 commands Fax Class 1 commandsFax Class 2 commands Voice commands User Guide Address map Appendix C. System address mapsSystem memory map Address range Address range hex Size Description DecimalLPT3 DMA I/O address map Address hex Description Bits Byte pointerAddress hex Description Bits Byte pointer System resource DMA channel Data width System resourceUser Guide Appendix E. Notices Television output noticeTrademarks IBMIndex DVDPage Page Part Number 49P1040