IBM 2289, 6824 manual Laser compliance statement, Consignes de sécurité relatives au modem

Page 9

vNever install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

vNever touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

vUse caution when installing or modifying telephone lines.

vAvoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

vDo not use the telephone to report a gas leak in the vicinity of the leak.

Consignes de sécurité relatives au modem

Lors de l’utilisation de votre matériel téléphonique, il est important de respecter les consignes ci-après afin de réduire les risques d’incendie, d’électrocution et d’autres blessures :

vN’installez jamais de cordons téléphoniques durant un orage.

vLes prises téléphoniques ne doivent pas être installées dans des endroits humides, excepté si le modèle a été conçu à cet effet.

vNe touchez jamais un cordon téléphonique ou un terminal non isolé avant que la ligne ait été déconnectée du réseau téléphonique.

vSoyez toujours prudent lorsque vous procédez à l’installation ou à la modification de lignes téléphoniques.

vSi vous devez téléphoner pendant un orage, pour éviter tout risque de choc électrique, utilisez toujours un téléphone sans fil.

vEn cas de fuite de gaz, n’utilisez jamais un téléphone situé à proximité de la fuite.

Laser compliance statement

Some IBM Personal Computer models are equipped from the factory with a CD-ROM drive or a DVD-ROM drive. CD-ROM drives and DVD-ROM drives are also sold separately as options. CD-ROM drives and DVD-ROM drives are laser products. These drives are certified in the U.S. to conform to the requirements of the Department of Health and Human Services 21 Code of Federal Regulations (DHHS 21 CFR) Subchapter J for Class 1 laser products. Elsewhere, these drives are certified to conform to the requirements of the International Electrotechnical Commission (IEC) 825 and CENELEC EN 60 825 for Class 1 laser products.

When a CD-ROM drive or a DVD-ROM drive is installed, note the following handling instructions.

CAUTION:

Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

Removing the covers of the CD-ROM drive or DVD-ROM drive could result in exposure to hazardous laser radiation. There are no serviceable parts inside the CD-ROM drive or DVD-ROM drive. Do not remove the drive covers.

Some CD-ROM drives and DVD-ROM drives contain an embedded Class 3A or Class 3B laser diode. Note the following statement.

Safety Information vii

Image 9
Contents User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide To connect To disconnect Safety InformationLithium battery notice Modem safety informationConnexion Déconnexion Consignes de sécurité relatives au modem Laser compliance statementViii User Guide Information resources OverviewUser Guide Features Installing optionsAudio subsystem Security features Specifications Available options Tools requiredHandling static-sensitive devices Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector DescriptionRemoving the cover Identifying parts on the system board Locating componentsInstalling memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Physical security Connecting an additional IDE CD-ROM drive or DVD-ROM driveChanging the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Starting the IBM Setup Utility program Using the IBM Setup Utility programViewing and changing settings Exiting from the IBM Setup Utility programAdministrator password User passwordSetting, changing, and deleting a password Using Security Profile by DeviceSelecting a startup device Selecting a temporary startup deviceChanging the startup device sequence User Guide Updating flashing Bios from your operating system Updating flashing Bios from a disketteAppendix A. Updating System Programs System programsRecovering from a POST/BIOS update failure Basic AT commands Appendix B. Manual modem commandsExtended AT commands Enable RTS/CTS hardware flow control Guard tone disabledUS setting for off-hook-to-on-hook ratio Force DSR Signal High onMNP/V.42/V.42bis/V.44 commands Fax Class 1 commandsFax Class 2 commands Voice commands User Guide System memory map Appendix C. System address mapsAddress map Address range Address range hex Size Description DecimalLPT3 Address hex Description Bits Byte pointer DMA I/O address mapAddress hex Description Bits Byte pointer DMA channel Data width System resource System resourceUser Guide Television output notice Appendix E. NoticesIBM TrademarksDVD IndexPage Page Part Number 49P1040