Fujitsu FMC-16LX FAMILY, FLASH-CAN-100 manual Uart, Can Interface X2

Change even page title here

Chapter 7 Connectors

7.4UART (X4)

One 9-pin D-Sub female connectors are used for the serial interface (UART).

TXD is the transmit output, RXD is the receive input. The DTR signal can be used to generate a reset. Please use 1:1 cable for PC-connection.

Connector X4:

	GND DTR RxD TxD
5	1
9	6

CTS RTS DSR

7.5CAN Interface (X2, X3)

Two 9-pin D-Sub male connector
are used for the CAN interface.		GND	CANL
Adjust both potentiometers (P1, P2) clockwise
to their end position.
(Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)	5			1
	9			6

Connector X2, X3:

CANH

UG-900001-32 - 16 - © Fujitsu Microelectronics Europe GmbH