Fujitsu FMC-16LX FAMILY, FLASH-CAN-100 manual Overview, Abstract, Introduction

Change even page title here

Chapter 1 Overview

1 Overview

1.1Abstract

This user guide describes the basic features of the new FLASH-CAN-100P-M06/FLASH- CAN2-100P-M06 board. This board can be used with almost all our 16LX microcontroller series supporting the FPT-100P-M06 package.

1.2Introduction

The "Flash/CAN100"-board was developed in order to support customers and allow a fast software design start. Fujitsu emulators require a target system that provides Vcc and GND as well as an oscillation circuit. Additionally most of Fujitsu’s flash microcontroller support the burn-in flash programming algorithm.

For the FLASH-CAN-100P-M06 board an IC149-100-114-B5 socket adapter is used. The suitable emulation probe cable is the MB2132-457.

On the FLASH-CAN2-100P-M06 board a NQPACK100RB socket adapter is assembled. This requires the MB2132-464 for the connection to the emulator.

This board must only be used for test applications

in an evaluation laboratory environment.

1.3Connectivity problems of the socket adapter

Some customers experience connectivity problems when connecting the MCU into the socket adapter. Only the small red screwdriver available in your box should be used to connect the cover (HQPACK) onto the socket (NQPACK).

If the four screws are not tightening equally, then it may cause a poor contact.

Do not screw the cover too tight (max 0.054 Nm). If you have connectivity problems then please loosen the screws and tighten again the screws equally.

Do not clean NQPACK, YQPACK, and YQSOCKET with steam. Cleaning material will contaminate inside of connector.

Customers using the FLASH-CAN-100P-M06 (with IC-149-100-114-B5 socket adapter) do usually not encounter this problem with the FLASH device.

UG-900001-32 - 6 - © Fujitsu Microelectronics Europe GmbH