Fujitsu 5000 user manual Location of Installation, Mounting Feet, Vertical Placement

Page 23

1 Installation

This section describes the location and installation of the PC.

Location of Installation

Avoid the following conditions when installing your PC.

Location with a large amount of humidity, dusts and oily smoke.

Location with poor ventilation.

Location with a fire source.

Bathroom, shower room, and other location with water splashes.

Location with elevated temperature such as direct sunlight or heating equipment.

Location at the temperature below 10°C.

Location with power cords and cables that may catch your foot.

Location with strong magnetic fields such as TV or speaker.

On top of unstable surface, such as vibrated or slant surface.

Mounting Feet

Vertical Placement

When using two feet

When installing your PC in the vertical layout away from a wall,use the following installation procedure.

1 Make sure that feet do not exceed the PC width.

2Mount the feet onto the PC unit. Fix all feet by tightening setscrews.

10

Image 23
Contents Deskpower 5000 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Point Conventions Used in This ManualDiskcopy a a Command entry keyingCD-ROM drive\setup.exe Screenshot example and illustrations Representation for Bios SetupReference to products Disposal of batteries RecyclingDisposal of the PC unit Disposal of the LCD unitRear of the PC main unit Before Reading This Manual Organization of This ManualContents List of Specifications Before Installing a Peripheral Device Removing the CoverInstalling Memory Modules Installing an Expansion CardChapter Front of the PC Unit Power buttonPower lamp Part Names and FunctionsFloppy disk access lamp Disk access lampUSB connector CD access lampExpansion card slots Keyboard connector Connect the keyboardRear of the PC Unit Burglarproof lockLine in terminal Serial connectorParallel connector CRT connectorInternal hard disk drive Power supply unitInside the PC Unit Motherboard Secondary IDE connector IDE2Floppy disk drive connector FDD Primary IDE connector IDE1 Internal batteryInstallation Connection Mounting Feet InstallationLocation of Installation Vertical PlacementPage Example of Installation Point Connection Connecting the mouse Connecting the Display/Keyboard/MousePlugging the power cord into power receptacle Plugging the power cord into inlet of display unitConnecting the display cable to the PC unit Connecting the keyboardConnect the Power Cord Page Power On How to Power On Considerations Setting UpClick Ignore Setting Up Windows XPTurn on the PC Click NextTurn on the computer Setting Up Windows PointClick Perform Click OK. The PC restartsClick User for this computer... and Next Click Standard setting and NextSelect Restart and click OK Problem During Setup? For Windows XP How to Turn OffTurn Off the Computer For Windows Me For WindowsHardware Keyboard Alt key Caps Lock keyCtrl key Windows keyGuidelines for CD Media CDsPull the tray out with a hand Inserting or Removing a CDInserting a CD Press the CD eject buttonManually push the tray until it clicks Removing the CDInserting a Floppy Disk Floppy DisksInserting or Removing a Floppy Disk Point Removing a Floppy Disk Make sure that the floppy disk access lamp is offHard Disk Remove the ball and clean it with water Maintenance of the HardwareMaintenance of the PC Unit Maintenance of the MouseClean the inside of the mouse Maintenance of the KeyboardCleaning CDs Cleaning the Floppy Disk DriveSystem Expansion Before Installing a Peripheral Device Use an appropriate screwdriver Remove the two screws on the PC unit Remove the upper cover Removing the CoverRemoving the Cover Installing Memory Modules Memory Module Combinations Location of Memory Modules Applicable Memory ModulesInstalling Memory Modules Point Installing an Expansion Card Unplug the PC Remove the upper cover Installing an Expansion CardLocation of expansion Cards Applicable Expansion Cards Remove the slot cover Remove the expansion card mounting bracketPlug the PC Turn on the PC Install the expansion card mounting bracketReinstall the upper cover Insert the expansion card into the slotTechnical Information PC Specifications List of SpecificationsCPU CSMA/CD LAN functionCRT connector Connector SpecificationsParallel connector LAN connector 100BASE-TX/10BASE-TKeyboard Connector Serial connectorMouse connector Glossary Symbol
Related manuals
Manual 82 pages 52.81 Kb