Fujitsu M3093DE/DG manual Cleaning area, Flatbed

Page 31

Cleaning area

	Area	Name	Cleaning paper	Dry cloth	Cotton swab
	Area	Name	with Cleaner F1	with Cleaner F1	with Cleaner F1 or F2
			with Cleaner F1	with Cleaner F1	with Cleaner F1 or F2
	Flatbed	Document holding pad
	Flatbed	Document bed
		Pad
		Glass/Sheet guide
	ADF	Pick roller
		Pick roller
		Plastic rollers
		Feed rollers

Document holding pad

ADF

Document bed

CLEANING

Feed rollers

Pad	Sheet guide(White part)

Feed rollers

Glass

Plastic rollers

Pick roller

Plastic rollers

3-3

Image 31

Contents M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Guide a AssembliesRetaining Thumb screw Spring Consumables Bearing Power Read Check IndicatorsPower Page Operating Instruction Lift up the ADF lever to open Loading Document on the ADFIt clicks Set the paper select lever as FollowsClose the ADF Pull up the ADF paper chute untilDocument on the ADF paper Fan the sheets before settingChute Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Supplies Cleaning Supplies and Cleaning AreaFlatbed Cleaning areaCleaning the ADF Remove dirt and dust as follows Lift up the ADF lever to open the ADFPick roller Sheet guide white part Wipe the sheet guide Wipe the Plastic roller Cleaner F2Surface with clean and dry Moisten a cotton swab withAllow to dry Cleaning the FlatbedApply Cleaner F1 to a clean cloth Wipe the document holding padReplacement of Parts Slide the pad ASY to the left Pad ASY or PadSlide the paper select Lever to NUntil it clicks in the reverse Attach the pad ASY to the ADFSequence of step Lift up the ADF lever to open Remove the two thumb screws Pick RollerLift and remove it Slide the pick roller to the retainingSpring side until the axis Opposite side is disengagedNew roller Attach the retaining spring to aSequence of and align Attach the Guide a in the reverseScrew hole Tighten the thumb screws Close the ADF unit Page Troubleshooting Close the ADF until the ADF lever Paper JAMRemove the documents from ADF paper chuteConnect the power cable correctly Press the power switch Contact manufacturer’s authorized service centerInitial Checks Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Host computer Select a Line Art mode fromSelect the Photo mode White level following off Clean the dirty partsIs the surface of the ADF Check Flatbed to read the document Clean the pick rollerClean or replace the Pad ASY Flatten the curl or useDo not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Flatten the curl or use the flatbed to read the document Install it correctly See p4-2Set the select lever to T. See p2-3 Replace the pick roller. See p4-4 Clean the pick roller. See p3-4, p3-6YES Test Mode for Maintenance LED status on error General Problem Checklist