Fujitsu M3093DE/DG manual Attach the Guide a in the reverse, Sequence of and align

Page 44

Guide A

10	Attach the Guide A in the reverse
	sequence of step 3 and align the

screw hole.

11	Tighten the thumb screws.
12	Close the ADF unit.

Thumb screws

REPLACEMENT OF PARTS

4-7

Image 44

Contents M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Retaining Thumb screw Spring Consumables Bearing AssembliesGuide a Power IndicatorsPower Read Check Page Operating Instruction Loading Document on the ADF Lift up the ADF lever to openSet the paper select lever as Follows Close the ADFPull up the ADF paper chute until It clicksChute Fan the sheets before settingDocument on the ADF paper Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Cleaning Supplies and Cleaning Area SuppliesCleaning area FlatbedCleaning the ADF Lift up the ADF lever to open the ADF Remove dirt and dust as followsPick roller Sheet guide white part Wipe the sheet guide Cleaner F2 Surface with clean and dryMoisten a cotton swab with Wipe the Plastic rollerCleaning the Flatbed Apply Cleaner F1 to a clean clothWipe the document holding pad Allow to dryReplacement of Parts Pad ASY or Pad Slide the paper selectLever to N Slide the pad ASY to the leftSequence of step Attach the pad ASY to the ADFUntil it clicks in the reverse Pick Roller Lift up the ADF lever to open Remove the two thumb screwsSlide the pick roller to the retaining Spring side until the axisOpposite side is disengaged Lift and remove itAttach the retaining spring to a New rollerScrew hole Tighten the thumb screws Close the ADF unit Attach the Guide a in the reverseSequence of and align Page Troubleshooting Paper JAM Remove the documents fromADF paper chute Close the ADF until the ADF leverInitial Checks Contact manufacturer’s authorized service centerConnect the power cable correctly Press the power switch Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Select a Line Art mode from Select the Photo mode White level following offClean the dirty parts Host computerIs the surface of the ADF Check Clean the pick roller Clean or replace the Pad ASYFlatten the curl or use Flatbed to read the documentDo not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Set the select lever to T. See p2-3 Install it correctly See p4-2Flatten the curl or use the flatbed to read the document Clean the pick roller. See p3-4, p3-6 Replace the pick roller. See p4-4YES Test Mode for Maintenance LED status on error Problem Checklist General