Fujitsu M3093DE/DG manual Is the baud rate System 4800 bps? Default is 4800 bps

Page 50

	Is the terminator con-	NO
	nected? Is the SCSI ID
	is set correctly?
	(M3093DG)
	YES
	Is the baud rate of the	NO
	Is the baud rate of the
	system 4800 bps?
	(Default is 4800 bps.)
	YES
		YES
Check	Is the CHECK indicator
Check	lit?
	lit?

NO

Contact manufacturer’s authorized service center.

Connect the terminator or set the SCSI ID correctly.

Contact manufacturer’s authorized service center to set correct baud rate.

Refer to Symptom 6.

(See p5-9)

TROUBLESHOOTING

5-5

Image 50

Contents M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Retaining Thumb screw Spring Consumables Bearing AssembliesGuide a Power IndicatorsPower Read Check Page Operating Instruction Loading Document on the ADF Lift up the ADF lever to openPull up the ADF paper chute until Set the paper select lever as FollowsClose the ADF It clicksChute Fan the sheets before settingDocument on the ADF paper Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Cleaning Supplies and Cleaning Area SuppliesCleaning area FlatbedCleaning the ADF Lift up the ADF lever to open the ADF Remove dirt and dust as followsPick roller Sheet guide white part Wipe the sheet guide Moisten a cotton swab with Cleaner F2Surface with clean and dry Wipe the Plastic rollerWipe the document holding pad Cleaning the FlatbedApply Cleaner F1 to a clean cloth Allow to dryReplacement of Parts Lever to N Pad ASY or PadSlide the paper select Slide the pad ASY to the leftSequence of step Attach the pad ASY to the ADFUntil it clicks in the reverse Pick Roller Lift up the ADF lever to open Remove the two thumb screwsOpposite side is disengaged Slide the pick roller to the retainingSpring side until the axis Lift and remove itAttach the retaining spring to a New rollerScrew hole Tighten the thumb screws Close the ADF unit Attach the Guide a in the reverseSequence of and align Page Troubleshooting ADF paper chute Paper JAMRemove the documents from Close the ADF until the ADF leverInitial Checks Contact manufacturer’s authorized service centerConnect the power cable correctly Press the power switch Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Clean the dirty parts Select a Line Art mode fromSelect the Photo mode White level following off Host computerIs the surface of the ADF Check Flatten the curl or use Clean the pick rollerClean or replace the Pad ASY Flatbed to read the documentDo not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Set the select lever to T. See p2-3 Install it correctly See p4-2Flatten the curl or use the flatbed to read the document Clean the pick roller. See p3-4, p3-6 Replace the pick roller. See p4-4YES Test Mode for Maintenance LED status on error Problem Checklist General