Fujitsu M3093DE/DG manual Symptom8 Paper double feed occurs frequently

Page 57

Symptom8 Paper double feed occurs frequently.

N:NORMAL T:THICK

N

T

Does the condition of	NO
the document satisfy
the requirements on
page 5-11.
YES
Is the plain paper read	YES
Is the plain paper read
with the select lever set
to “T”?
NO
Are the documents	NO
fanned and angled before
loading on the ADF paper
chute?
YES

Flatten the curl or use the flatbed to read the document.

Set the select lever to “N”. (See p2-3)

Fan and angle the documents before loading according to the procedure on the pages 2-3 and 2-4.

Is the paper printed by copier or laser printer recentry?

NO

YES

Fan 3 or 4 times to remove the static charge applied on paper.

5-12

Image 57

Contents M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Assemblies Guide aRetaining Thumb screw Spring Consumables Bearing Indicators Power Read CheckPower Page Operating Instruction Lift up the ADF lever to open Loading Document on the ADFClose the ADF Set the paper select lever as FollowsPull up the ADF paper chute until It clicksFan the sheets before setting Document on the ADF paperChute Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Supplies Cleaning Supplies and Cleaning AreaFlatbed Cleaning areaCleaning the ADF Remove dirt and dust as follows Lift up the ADF lever to open the ADFPick roller Sheet guide white part Wipe the sheet guide Surface with clean and dry Cleaner F2Moisten a cotton swab with Wipe the Plastic rollerApply Cleaner F1 to a clean cloth Cleaning the FlatbedWipe the document holding pad Allow to dryReplacement of Parts Slide the paper select Pad ASY or PadLever to N Slide the pad ASY to the leftAttach the pad ASY to the ADF Until it clicks in the reverseSequence of step Lift up the ADF lever to open Remove the two thumb screws Pick RollerSpring side until the axis Slide the pick roller to the retainingOpposite side is disengaged Lift and remove itNew roller Attach the retaining spring to aAttach the Guide a in the reverse Sequence of and alignScrew hole Tighten the thumb screws Close the ADF unit Page Troubleshooting Remove the documents from Paper JAMADF paper chute Close the ADF until the ADF leverContact manufacturer’s authorized service center Connect the power cable correctly Press the power switchInitial Checks Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Select the Photo mode White level following off Select a Line Art mode fromClean the dirty parts Host computerIs the surface of the ADF Check Clean or replace the Pad ASY Clean the pick rollerFlatten the curl or use Flatbed to read the documentDo not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Install it correctly See p4-2 Flatten the curl or use the flatbed to read the documentSet the select lever to T. See p2-3 Replace the pick roller. See p4-4 Clean the pick roller. See p3-4, p3-6YES Test Mode for Maintenance LED status on error General Problem Checklist