vUser’s Guide and Software CD
vLaser Safety Guide
Contact your place of purchase if an item is missing or damaged. Be sure to retain your proof of purchase. It might be required to receive warranty service. See “Appendix D. Product warranty and support information” on page
Software description
The User’s Guide and Software CD contains the following software:
vIBM RecordNow: With RecordNow, you can record your own CDs in a variety of ways. You can use the CD copier function to make backup copies of your CDs, or you can make data CDs from files on your hard disk drive. You can also create audio CDs from MP3 files or from other audio CDs.
vIBM Drive Letter Access (DLA): You can use DLA to access your
Before you begin
Read the following information before you start your installation. You must complete the following steps to install the drive:
1.Determine which IDE port to use and the corresponding configuration setting.
2.Place or change the configuration jumper on the drive (you might need to make changes to the configuration jumpers of other devices).
3.Install the drive in a drive bay.
4.Configure the system.
5.Install software.
If you do not understand these procedures or are unsure about your ability to perform all the procedures described, contact a qualified computer technician to install the
System requirements
Before you begin installing the drive, be sure your computer meets the following system requirements.
vMinimum microprocessor: Intel® Pentium® processor (or the equivalent)
vMinimum RAM: 32 MB2
vAvailable IDE connection
2.When referring to memory storage capacity, MB means approximately 1 000 000 bytes; total