IBM 31P6240, 6331-H1N, 31P6241 manual Federal Communications Commision FCC Statement, Power Cords

Kerr74_54_compliance.fm Page 0 Wednesday, September 5, 2001 6:16 PM

Compliances

Federal Communications

Commision

(FCC) Statement

TestedTo Comply

W ith FCCtandardS

FOR HOME OR OFFICE USE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television receptions, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

!Reorient or relocate the receiving antenna.

!Increase the separation between the equipment and receiver.

!Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

!Consult the dealer or an experienced radio/TV

technician for help.

Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Proper cables and connectors are available from IBM authorized dealers. IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate the equipment.

Power Cords

For your safety, IBM provides a power cord with a grounded attachment plug to use with this IBM product. To avoid electrical shock, always use the power cord and plug with a properly grounded power outlet.

IBM power cords used in the United States and Canada are listed by the Underwriters Laboratories (UL) and certified by the Canadian Standards Association (CSA).

For units intended to be operated at 115 volts: Use a UL listed and

CSA-certified cord set consisting of a minimum 18 AWG, type SVT or SJT, three conductor cord, a maximum of

4.5m (15 ft) in length and a parallel blade, grounding type attachment plug rated 15 amperes, 125 volts.

For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set consisting of a minimum 18 AWG, type SVT or SJT, three conductor cord, a maximum of 4.5 m (15 ft) in length and a tandem blade, grounding type attachment plug rated 15 amperes, 250 volts.

For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding type attachment plug rated 13 amperes (minimum), 250 volts. Use a cord set with a grounding type attachment plug. The cord set should have the appropriate safety approvals for the country in which the equipment will be installed.

IBM power cords for a specific country or region are usually available only in that country or region.

IBM Fig. #	IBM P/N	Using Countries or
(Plug Stnd.)	(1.8M)	Regions
		US, Canada, Mexico,
		Brazil, Costa Rica, Peru,
		Colombia, Ecuador,
4		Venezuela, Bolivia,
		Panama, El Salvador,
(NEMA 5-15P)	6952301
		Honduras, Nicaragua,
125V
		Dominican Republic,
		Guatemala, Taiwan, Saudi
		Arabia, Thailand,
		Phillipines, Japan
		US, Canada, Mexico,
		Brazil, Costa Rica, Peru,
		Colombia, Ecuador,
5		Venezuela, Bolivia,
		Panama, El Salvador,
(NEMA 6-15P)	1838576
		Honduras, Nicaragua,
250V
		Dominican Republic,
		Guatemala, Taiwan, Saudi
		Arabia, Thailand,
		Phillipines, Japan
6	13F9939	Australia, New Zealand
(AS/NZS C112)

Portuguese Italiano Español Deutsch Français English