Cisco Systems WSC2960X48TDL Power inline police actionlog errdisable Exit, Configuration mode

Configuring PoE

Configuring Power Policing

SUMMARY STEPS

1.configure terminal

2.interface interface-id

3.power inline police [action{log errdisable}]

4.exit

5.Use one of the following:

•errdisable detect cause inline-power

•errdisable recovery cause inline-power

•errdisable recovery interval interval

6.exit

7.Use one of the following:

•show power inline police

•show errdisable recovery

DETAILED STEPS

	Command or Action	Purpose
Step 1	configure terminal	Enters global configuration mode.
	Example:
	Switch# configure terminal
Step 2	interface interface-id	Specifies the physical port to be configured, and enter interface
		configuration mode.
	Example:
	Switch(config)# interface
	gigabitethernet2/0/1

Step 3 power inline police [action{log errdisable}]

Example:

Switch(config-if)# power inline police

If the real-time power consumption exceeds the maximum power allocation on the port, configures the switch to take one of these actions:

•power inline police—Shuts down the PoE port, turns off power to it, and puts it in the error-disabled state.

Note You can enable error detection for the PoE error-disabled cause by using the errdisable detect cause inline-powerglobal configuration command. You can also enable the timer to recover from the PoE error-disabled state by using the errdisable recovery cause inline-power interval interval global configuration command.

•power inline police action errdisable—Turns off power to the port if the real-time power consumption exceeds the maximum power allocation on the port.

	Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX
86	OL-29034-01