Cisco Systems WSC2960X48TDL manual Configuration Examples for System MTU

Configuring System MTU

Configuration Examples for System MTU

	Command or Action
Step 2	system mtu bytes

Example:

Switch(config)# system mtu 2500

Step 3 system mtu jumbo bytes

Example:

Switch(config)# system mtu jumbo 7500

Step 4 end

Example:

Switch(config)# end

Purpose

(Optional) Change the MTU size for all interfaces on the switch stack that are operating at 10 or 100 Mb/s.

The range is 1500 to 1998 bytes; the default is 1500 bytes.

(Optional) Changes the MTU size for all Gigabit Ethernet interfaces on the switch or the switch stack.

The range is 1500 to 9198 bytes; the default is 1500 bytes.

Returns to privileged EXEC mode.

Step 5	copy running-config startup-config	Saves your entries in the configuration file.
	Example:
	Switch# copy running-config startup-config
Step 6	reload	Reloads the operating system.
	Example:
	Switch# reload
Step 7	show system mtu	Verifies your settings.
	Example:
	Switch# show system mtu

Configuration Examples for System MTU

This example shows how to set the maximum packet size for a Gigabit Ethernet port to 7500 bytes:

Switch(config)# system mtu jumbo 7500

Switch(config)# exit

Switch# reload

If you enter a value that is outside the allowed range for the specific type of interface, the value is not accepted. This example shows the response when you try to set Gigabit Ethernet interfaces to an out-of-range number:

Switch(config)# system mtu jumbo 25000

^

% Invalid input detected at '^' marker.

Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29034-01 73