Chapter 6 Managing the Device Hardware
EPLD Configuration
Se n d d o c u m e n t c o m m e n t s t o n ex u s 7 k - d o c f e e d b a ck @ c i s c o . c o m
| Fan: |
|
|
|
| ||||
| Fan | Model | Hw | Status |
| ||||
| Fan1(sys_fan1) |
| 0.0 | Ok |
| Fan2(sys_fan2) |
| 0.0 | Ok |
| Fan3(fab_fan1) |
| 0.0 | Ok |
| Fan4(fab_fan2) |
| 0.0 | Ok |
| Fan_in_PS1 | Ok | ||
| Fan_in_PS2 | Ok | ||
| Fan_in_PS3 | Ok | ||
| Fan Air Filter : Absent |
|
| |
| switch# |
|
|
|
Step 2 | Upgrade the EPLD images for the fan tray module by entering the install | |||
| url command. |
|
|
|
switch# install
EPLD image file , built on Fri May 16 20:36:39 2008
EPLDCurr Ver New Ver
Fan Controller | 0.5 | 0.7 |
Fan Controller | 0.5 | 0.7 |
WARNING: Upgrade process could upto 30 minutes. |
| |
Module could be powered down and up. |
| |
Programming Fan Module 1 !! |
|
|
Do you want to continue (y/n) ? | [n] |
|
Step 3 Confirm the upgrade by entering Y for yes.
...
Do you want to continue (y/n) ? [n] y
To confirm the EPLD upgrade, see the “Displaying EPLD Versions for a Fan Tray Module” section on page
Displaying the EPLD Versions
These topics describe how to display the EPLD versions on each module in your system and display the available EPLD versions:
•Displaying EPLD Versions for an I/O or Supervisor Module, page
•Displaying EPLD Versions for a Fabric Module, page
•Displaying EPLD Versions for a Fan Tray Module, page
•Displaying the Available EPLD Versions, page
Displaying EPLD Versions for an I/O or Supervisor Module
To display all of the current EPLD versions on a specific I/O or supervisor module, use the show version module slot_number epld command as shown in Example 14.
|
| Cisco Nexus 7000 Series Hardware Installation and Reference Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
|