Chapter 3 Installing a Cisco Nexus 7018 Chassis
Installing and Formatting CompactFlash Cards
Se n d d o c u m e n t c o m m e n t s t o n ex u s 7 k - d o c f e e d b a ck @ c i s c o . c o m
Tip Whenever you need to open the door, pull one of the door handles open until it clicks and then swing that side of the door open.
Note If the
Installing and Formatting CompactFlash Cards
Each supervisor module on a Cisco Nexus 7018 system is shipped with a CompactFlash card installed in the LOG FLASH reader. The EXPANSION FLASH reader is left empty, but you can optionally install a card in that reader. For the card to function with the reader, you must make sure that it is either formatted for the reader before installing it or format it after installing it.
Note The LOG FLASH and EXPANSION FLASH readers require different formats for their cards.
To replace an installed CompactFlash card, see the “Replacing a CompactFlash Card” section on page
To install a CompactFlash card, follow these steps:
Step 1 Align the card with the slot for the CompactFlash reader slot that is labeled LOG FLASH or EXPANSION FLASH as shown in Figure
Figure 3-22 Aligning a CompactFlash Card to its Reader
189555 |
Step 2 Push the card all the way into the reader.
If the card does not fit easily into the reader, flip the card so the bottom edge is on top, and try pushing the card into the reader.
Step 3 Wait for the reader LED to turn green and for a message to appear on the console as follows:
•If you are installing a card into the log flash reader, the message will end with “logflash:online.”
switch# 2008 Mar 15 08:00:00 switch %$
•If you are installing a card into the expansion flash reader, the message will end with “slot0:online.”
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
|
| ||
|
|