Chapter 3 Installing a Cisco Nexus 7018 Chassis
Installing the Bottom-Support Rails on the Rack
Se n d d o c u m e n t c o m m e n t s t o n ex u s 7 k - d o c f e e d b a ck @ c i s c o . c o m
To attach the bottom-support rails to a four-post EIA rack, follow these steps:
Step 1 Position one of the two adjustable bottom-support rails at the lowest possible RU as shown in Figure 3-1. Adjust the length of the rail so that it stretches from the outer edges of the front and rear vertical mounting rails. You can expand the rail so that its mounting brackets are spaced between 24 to 32 inches (61.0 to 81.3 cm).
Note Make sure that the two bottom-support rails are level with one another. If they are not level, adjust the higher rail down to the level of the lower rail.
Figure 3-1 Positioning the Bottom-Support Rails
2
192147
1
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
