Cisco Systems manual Rack-Mounting the Cisco SFS 7000P Switch, Requirements

Chapter 2 Installing the Cisco SFS 7000P Switch

Rack-Mounting the Cisco SFS 7000P Switch

Step 5 Check the LEDs on the front of the Cisco SFS 7000P system.

When the system first powers up, it performs a power-on self test (POST). See the “LEDs” section on page 4-1.

Step 6 Log in and assign a network address after you see the login prompt.

The default login is:

•super

For additional management information, see the Command Line Interface

Reference Guide.

Rack-Mounting the Cisco SFS 7000P Switch

This section describes how to install the Cisco SFS 7000P switch in an equipment rack.

Requirements

In addition to the accessories provided with the switch, you should have:

•A number 2 Phillips screwdriver

•12 screws and any associated mounting clips to secure the brackets to your rack (two for each rail of the rack).

Caution Installing the rack to the system with screws other than the ones provided could be hazardous.

•We recommend that two people install the switch in a rack.

Note The Cisco SFS 7000P switch weighs more than 22 pounds (10 kg).

	Cisco SFS 7000P Hardware Installation Guide
OL-9167-01 Rev. A0		2-5