Chapter 3 Installing Supervisor Engines
Installing a Supervisor Engine
Step 9 Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the following two sets of steps:
Chassis with horizontal slots
a.Position the new supervisor engine in the slot. Make sure that you align the sides of the supervisor engine carrier with the slot guides on each side of the chassis slot. (See Figure
b.Carefully slide the supervisor engine into the slot until the EMI gasket along the top edge of the supervisor engine makes contact with the module or cover plate in the slot above it and the supervisor engine ejector levers have both closed to approximately 45 degrees with respect to the supervisor engine faceplate.
Figure 3-1 Positioning the Supervisor Engine in a Horizontal Slot Chassis
Insert module |
| |
between slot guides | EMI gasket | |
| 3 |
|
4 | 4 |
|
|
| |
5 | 5 |
|
|
| |
6 | 6 |
|
|
|
FAN STATUS
1
2
3
4
5
EMI gasket | o |
| o |
| INPUT FAN OUTPUT |
| FAIL |
INPUT | FAN OUTPUT |
O | FAIL |
130908
Ejector lever fully extended
Catalyst 6500 Series Supervisor Engine Guide
|
| ||
|
|