Chapter 1 About the Server Switch Module
Introduction
Figure 1-1 Cisco 4x InfiniBand Switch Module for IBM BladeCenter
154589
Each Server Switch Module includes 16 4x ports to the backplane and 8 4x ports (in the form of 2 4x connectors and 2 12x connectors) on the front panel. The Server Switch Module provides full
Server Switch Modules transmit information to and from BladeCenter Management Modules over Ethernet (through an internal Ethernet switch) to facilitate setup and management. After you set up a Server Switch Module and bring it online, the
Cisco Server Switch Modules allow you to perform a field upgrade to load the latest firmware on the Server Switch Module. You can perform a firmware upgrade even following a failed upgrade. CLI and GUI interfaces both support upgrades. For details, see the Command Line Interface Reference Guide or the Element Manager User Guide.
Server Switch Module and HCA Expansion Cards
Within the BladeCenter unit, Server Switch Modules manage traffic to and from HCA expansion cards on the BladeCenter hosts. Each HCA expansion card adds two IB ports to a BladeCenter host. Each HCA port connects through the unit backplane to a particular Server Switch Module slot. The first IB port of each HCA card (ib0) connects to the Server Switch Module in I/O slot 7, and the second IB port of each HCA card (ib1) connects to I/O slot 9. For detailed information about the HCA expansion card, see the Cisco 4x InfiniBand HCA Expansion Card for IBM BladeCenter User Guide.
Cisco 4x InfiniBand Switch Module for IBM BladeCenter User Guide
| ||
|