Cisco Systems Network Switch Cabling manual Set the host name of the switch stack, as follows

Page 11

7. Set the host name of the switch stack, as follows:

At this prompt...

Enter...

Notes

 

 

 

Switch(config)#

hostname sw01

Use your site-specific name instead

 

 

of sw01 used as an example; each

 

 

switch should have a unique name.

 

 

 

8.

Set the switch stack’s enable password, as follows:

 

At this prompt...

Enter...

Notes

 

 

 

sw01(config)#

enable secret system

Use your site-specific password

 

 

instead of the system password used

 

 

as an example.

 

 

 

9.

Turn off the VLAN trunking protocol (VTP), as follows:

At this prompt...

Enter...

 

Notes

 

 

 

 

 

sw01(config)#

vtp mode transparent

 

Displays the following output:

 

sw01(config)#

 

 

 

Setting device to VTP TRANSPARENT mode.

 

 

10.

Enable the portfast bpduguard feature, as follows:

 

 

 

 

 

 

At this prompt...

Enter...

 

Notes

 

 

 

 

sw01(config)#

spanning-tree portfast bpduguard default

 

Enabling this feature protects

 

 

 

against cabling errors. If a spanning

 

 

 

tree packet does arrive on a port

 

 

 

that has this feature enabled, the

 

 

 

port is disabled.

 

 

 

 

 

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

26

Image 11
Contents Port numbering Control Node and Network Switch Cabling ExampleSwitch Panel and Control Node Cabling Shows how each port is used on the switch and control node Up application nodes Racking and cabling guidelinesThen Connecting the switch to a terminal server Configuring the switchesDelete the Vlan database, as follows Restoring the factory default settingsRenumber the switch, as follows Enter the configuration mode, as followsHalt and perform a cold restart, as follows Setting switch optionsExit the configuration mode, as follows Turn the messages off, as follows Enter the configuration mode, as followsTurn off all interfaces on the first switch, as follows Enter the privileged mode, as followsTurn off the Vlan trunking protocol VTP, as follows Set the host name of the switch stack, as followsSet the switch stack’s enable password, as follows Should be sent over it Set the interface connection to the router, as followsSetting the portfast option means Message as required by Disable Igmp snooping, as followsTurn off the Http server, as follows Set the message of the day, as followsTurn logging to the console back on, as follows Exit the configuration mode, as followsVerify the switch configuration, as follows Turn all the interfaces back on, as followsPage XXX Displays the following output