Cisco Systems Network Switch Cabling manual

Page 16

interface Port-channel1 no ip address

!

interface GigabitEthernet1/0/1 no ip address

no mdix auto channel-group 1 mode on

!

interface GigabitEthernet1/0/2 switchport mode access

no ip address no mdix auto

!

interface GigabitEthernet1/0/3 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet1/0/4 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet1/0/5 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet1/0/6 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

...

<ports 7 through 23 output on the first switch in the switch stack should be the same as shown above for interface GigabitEthernet1/0/6>

...

interface GigabitEthernet1/0/24 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet2/0/1 no ip address

no mdix auto channel-group 1 mode on

!

interface GigabitEthernet2/0/2 switchport mode access

no ip address no mdix auto spanning-tree portfast

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

31

Image 16
Contents Control Node and Network Switch Cabling Example Port numberingSwitch Panel and Control Node Cabling Shows how each port is used on the switch and control node Racking and cabling guidelines Up application nodesThen Configuring the switches Connecting the switch to a terminal serverRestoring the factory default settings Delete the Vlan database, as followsEnter the configuration mode, as follows Renumber the switch, as followsExit the configuration mode, as follows Setting switch optionsHalt and perform a cold restart, as follows Enter the configuration mode, as follows Turn off all interfaces on the first switch, as followsEnter the privileged mode, as follows Turn the messages off, as followsSet the switch stack’s enable password, as follows Set the host name of the switch stack, as followsTurn off the Vlan trunking protocol VTP, as follows Set the interface connection to the router, as follows Should be sent over itSetting the portfast option means Disable Igmp snooping, as follows Turn off the Http server, as followsSet the message of the day, as follows Message as required byExit the configuration mode, as follows Verify the switch configuration, as followsTurn all the interfaces back on, as follows Turn logging to the console back on, as followsPage XXX Displays the following output