Cisco Systems Network Switch Cabling manual Displays the following output

Page 18

21.

Save the configuration across a reboot of the switch, as follows:

 

 

 

 

At this prompt...

 

Enter...

Notes

 

 

 

 

sw01#

 

copy running-config startup-config

Displays the following output:

 

Destination filename [startup-config]?

 

 

Building configuration...

 

 

[OK]

 

 

sw01#

 

22.

Configure the second Cisco switch stack by repeating step 1 in Connecting the switch to a

 

terminal server on page 21 through step 21 in Setting switch options on page 24.

When you have completed configuring all switch stacks, plug them in.

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

33

Image 18
Contents Control Node and Network Switch Cabling Example Port numberingSwitch Panel and Control Node Cabling Shows how each port is used on the switch and control node Racking and cabling guidelines Up application nodesThen Configuring the switches Connecting the switch to a terminal serverRestoring the factory default settings Delete the Vlan database, as followsEnter the configuration mode, as follows Renumber the switch, as followsSetting switch options Exit the configuration mode, as followsHalt and perform a cold restart, as follows Enter the privileged mode, as follows Enter the configuration mode, as followsTurn off all interfaces on the first switch, as follows Turn the messages off, as followsSet the host name of the switch stack, as follows Set the switch stack’s enable password, as followsTurn off the Vlan trunking protocol VTP, as follows Set the interface connection to the router, as follows Should be sent over itSetting the portfast option means Set the message of the day, as follows Disable Igmp snooping, as followsTurn off the Http server, as follows Message as required byTurn all the interfaces back on, as follows Exit the configuration mode, as followsVerify the switch configuration, as follows Turn logging to the console back on, as followsPage XXX Displays the following output