Cisco Systems Network Switch Cabling manual Setting switch options

Page 9

Changing Switch Number 3 to Switch Number 2 New Switch Number will be effective after next reboot

6. Exit the configuration mode, as follows:

At this prompt...

Enter...

 

Notes

 

 

 

 

 

 

sw01#

exit

 

 

 

7. Halt and perform a cold restart, as follows:

 

 

 

 

 

 

 

At this prompt...

Enter...

Notes

 

 

 

 

 

 

sw01>

reload

 

 

 

System configuration has been modified.

no

 

 

 

Save? [yes/no]:

 

 

 

 

Proceed with reload? [confirm]

y

Displays the following output:

 

00:08:23: %SYS-5-RELOAD: Reload requested

Base ethernet MAC Address: 00:11:bb:7e:94:80 Xmodem file system is available.

The password-recovery mechanism is enabled. Initializing Flash...

flashfs[0]: 79 files, 4 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 15998976

flashfs[0]: Bytes used: 6457856

flashfs[0]: Bytes available: 9541120

flashfs[0]: flashfs fsck took 8 seconds.

...done Initializing Flash.

Boot Sector Filesystem (bs) installed, fsid: 3 done.

...

Press RETURN to get started!

Proceed to step 1 in Setting switch options on page 24 to continue the switch configuration procedure.

Setting switch options

This procedure provides the minimal configuration required to support the reference system. Configure the first switch stack as follows:

1. Select the Enter key to get started. Skip the initial configuration, as follows:

At this prompt...

Enter...

Notes

 

 

 

--- System Configuration Dialog ---

no

 

would you like to enter the initial configuration

 

 

dialog? [yes/no]:

 

 

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

24

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Port numbering Control Node and Network Switch Cabling ExampleSwitch Panel and Control Node Cabling Shows how each port is used on the switch and control node Up application nodes Racking and cabling guidelinesThen Connecting the switch to a terminal server Configuring the switchesDelete the Vlan database, as follows Restoring the factory default settingsRenumber the switch, as follows Enter the configuration mode, as followsSetting switch options Exit the configuration mode, as followsHalt and perform a cold restart, as follows Turn off all interfaces on the first switch, as follows Enter the configuration mode, as followsEnter the privileged mode, as follows Turn the messages off, as followsSet the host name of the switch stack, as follows Set the switch stack’s enable password, as followsTurn off the Vlan trunking protocol VTP, as follows Should be sent over it Set the interface connection to the router, as followsSetting the portfast option means Turn off the Http server, as follows Disable Igmp snooping, as followsSet the message of the day, as follows Message as required byVerify the switch configuration, as follows Exit the configuration mode, as followsTurn all the interfaces back on, as follows Turn logging to the console back on, as followsPage XXX Displays the following output
Top Page Image Contents