Cisco Systems Network Switch Cabling manual Turn all the interfaces back on, as follows

Page 15

17. Turn all the interfaces back on, as follows:

At this prompt...

Enter...

Notes

 

 

 

sw01(config)#

interface range GigabitEthernet 1/0/1 - 24

 

sw01(config-if-range)#

no shutdown

 

sw01(config-if-range)#

exit

 

sw01(config)#

interface range GigabitEthernet 2/0/1 - 24

 

sw01(config-if-range)#

no shutdown

 

sw01(config-if-range)#

exit

 

18. Turn logging to the console back on, as follows:

 

 

 

 

At this prompt...

Enter...

Notes

 

 

 

sw01(config)#

logging console

 

19. Exit the configuration mode, as follows:

 

 

 

 

At this prompt...

Enter...

Notes

 

 

 

sw01(config)#

exit

 

20. Verify the switch configuration, as follows:

 

 

 

 

At this prompt...

Enter...

Notes

 

 

 

sw01#

show running-config

Displays the following output:

Building configuration...

Current configuration : 3230 bytes

!

Version 12.1 no service pad

service timestamps debug uptime service timestamps log uptime no service password-encryption

!

hostname sw01

!

enable secret 5 $1$45RQ$hd1IzO.vm5WKRsLXyZoFx0

!

ip subnet-zero

no ip igmp snooping

!

vtp mode transparent

!

spanning-tree mode pvst spanning-tree portfast bpduguard default

no spanning-tree optimize bpdu transmission spanning-tree extend system-id

!

!

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

30

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Port numbering Control Node and Network Switch Cabling ExampleSwitch Panel and Control Node Cabling Shows how each port is used on the switch and control node Up application nodes Racking and cabling guidelinesThen Connecting the switch to a terminal server Configuring the switchesDelete the Vlan database, as follows Restoring the factory default settingsRenumber the switch, as follows Enter the configuration mode, as followsSetting switch options Exit the configuration mode, as followsHalt and perform a cold restart, as follows Turn the messages off, as follows Enter the configuration mode, as followsTurn off all interfaces on the first switch, as follows Enter the privileged mode, as followsSet the host name of the switch stack, as follows Set the switch stack’s enable password, as followsTurn off the Vlan trunking protocol VTP, as follows Should be sent over it Set the interface connection to the router, as followsSetting the portfast option means Message as required by Disable Igmp snooping, as followsTurn off the Http server, as follows Set the message of the day, as followsTurn logging to the console back on, as follows Exit the configuration mode, as followsVerify the switch configuration, as follows Turn all the interfaces back on, as followsPage XXX Displays the following output
Top Page Image Contents