Cisco Systems Network Switch Cabling manual Xxx

Page 17

!

interface GigabitEthernet2/0/3 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet2/0/4 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet2/0/5 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface GigabitEthernet2/0/6 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

...

<ports 7 through 23 output on the first switch in the switch stack should be the same as shown above for interface GigabitEthernet2/0/6>

...

interface GigabitEthernet2/0/24 switchport mode access

no ip address no mdix auto spanning-tree portfast

!

interface Vlan1 no ip address shutdown

!

ip classless

no ip http server

!

banner motd ^C

*************************************

XXX

*************************************

^C

!

line con 0 line vty 5 15

!

end

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

32

Image 17

Contents Port numbering Control Node and Network Switch Cabling ExampleSwitch Panel and Control Node Cabling Shows how each port is used on the switch and control node Up application nodes Racking and cabling guidelinesThen Connecting the switch to a terminal server Configuring the switchesDelete the Vlan database, as follows Restoring the factory default settingsRenumber the switch, as follows Enter the configuration mode, as followsHalt and perform a cold restart, as follows Setting switch optionsExit the configuration mode, as follows Turn off all interfaces on the first switch, as follows Enter the configuration mode, as followsEnter the privileged mode, as follows Turn the messages off, as followsTurn off the Vlan trunking protocol VTP, as follows Set the host name of the switch stack, as followsSet the switch stack’s enable password, as follows Should be sent over it Set the interface connection to the router, as followsSetting the portfast option means Turn off the Http server, as follows Disable Igmp snooping, as followsSet the message of the day, as follows Message as required byVerify the switch configuration, as follows Exit the configuration mode, as followsTurn all the interfaces back on, as follows Turn logging to the console back on, as followsPage XXX Displays the following output