Chapter 1 Introduction
Hardware Features
Ethernet Port
Your GSS 4490 comes with one integrated dual-port Ethernet controller. This controller provides an interface for connecting to 10-Mbps, 100-Mbps, or 1000-Mbps networks and support autonegotitate, full-duplex, or half-duplex operation on an Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair (UTP) cable to the RJ-45 connector on the back of the device.
Note The 100BASE-TX/1000BASE-TX Ethernet standard requires that the cabling in the network be Category 5 or higher.
Figure 1-7shows the pin number assignments for the Ethernet RJ-45 port.
Figure 1-7 Ethernet Port Connector
Link LED | Activity (TX/RX)LED |
(green) | (green) |
| 97447 |
8 1
Console Port
Your GSS 4490 has one standard RS 232 serial port located on the back of the device. Figure 1-8shows the pin number assignments for the 9-pin, male D-shell serial port connector on the back of the GSS 4490. These pin number assignments conform to the industry standard.
Cisco Global Site Selector 4490 Hardware Installation Guide
