Cisco Systems 4490 appendix Installing the Cisco Global Site Selector, C H A P T E R

Page 1

C H A P T E R 3

C H A P T E R 3

Installing the Cisco Global Site

Selector 4490

This chapter explains how to install a Cisco Global Site Selector 4490 in an equipment rack. It also provides general instructions for installing a GSS 4490 on a table or workbench.

This chapter contains the following major sections:

•Unpacking and Inspecting the Global Site Selector 4490

•Tools and Parts Required

•Installing Your Unit

•Connecting Cables

•Connecting Power

•Booting the System

•Checking the Front Panel LEDs

•Removing or Replacing a Cisco Global Site Selector 4490 Before you begin the installation be sure to read:

•Chapter 2, Preparing for Installation

•Appendix C, Regulatory Compliance and EMI Class A Warnings

•Regulatory Compliance and Safety Information for the Cisco Global Site Selector 4490

		Cisco Global Site Selector 4490 Hardware Installation Guide
		Cisco Global Site Selector 4490 Hardware Installation Guide
	78-15755-01			3-1
	78-15755-01			3-1

Image 1

Contents C H A P T E R Installing the Cisco Global Site SelectorUnpacking and Inspecting the Global Site Selector Cisco Global Site Selector Hardware Installation GuideIf the Product is Damaged Tools and Parts Required83198 Figure 3-1 Four-Post Rack Installation KitInstalling Your Unit Figure 3-2 Installing Clip Nuts or Cage Nuts in a Non-Threaded Rack Installing the Chassis in a Four-Post RackSlide rail assembly Figure 3-4 Attaching the Inner Slide Rail to the GSS 2 Adjustment screw Release tab 3-10Installing the Chassis in a Two-Post Rack 3-11Cisco Global Site Selector 4490 Hardware Installation Guide Chapter 3 Installing the Cisco Global Site SelectorRepeat this step to secure the left side bracket to the rack 3-123-13 Installing the Chassis on a Workbench or Tabletop3-14 Connecting CablesBooting the System Connecting Power3-15 3-16 Checking the Front Panel LEDsColor State3-17 Removing or Replacing a Cisco Global Site SelectorTable 3-1 Front Panel LEDs continued To physically remove a GSS 4490 from your network, follow these steps 3-18To physically replace a GSS 4490, follow these steps 3-193-20

Related manuals

Manual 94 pages 36.36 Kb

Manual 92 pages 54.88 Kb