Cisco Systems 4490 appendix Installing Your Unit

Page 5
Installing Your Unit

Chapter 3 Installing the Cisco Global Site Selector 4490

Installing Your Unit

Installing Your Unit

Place the unit in the desired location. You can mount it in a rack for your convenience, or place it on a solid, stable surface. If you do not plan to install the GSS 4490 in an equipment rack, proceed to the “Installing the Chassis on a Workbench or Tabletop” section.

Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:

This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.

This section contains the following procedures:

Installing the Chassis in a Four-Post Rack

Installing the Chassis in a Two-Post Rack

Installing the Chassis on a Workbench or Tabletop

 

 

Cisco Global Site Selector 4490 Hardware Installation Guide

 

 

 

 

 

 

78-15755-01

 

 

3-5

 

 

 

Image 5
Contents C H A P T E R Installing the Cisco Global Site SelectorUnpacking and Inspecting the Global Site Selector Cisco Global Site Selector Hardware Installation GuideIf the Product is Damaged Tools and Parts Required83198 Figure 3-1 Four-Post Rack Installation KitInstalling Your Unit Figure 3-2 Installing Clip Nuts or Cage Nuts in a Non-Threaded Rack Installing the Chassis in a Four-Post RackSlide rail assembly Figure 3-4 Attaching the Inner Slide Rail to the GSS 2 Adjustment screw Release tab 3-10Installing the Chassis in a Two-Post Rack 3-11Cisco Global Site Selector 4490 Hardware Installation Guide Chapter 3 Installing the Cisco Global Site SelectorRepeat this step to secure the left side bracket to the rack 3-123-13 Installing the Chassis on a Workbench or Tabletop3-14 Connecting Cables3-15 Connecting PowerBooting the System 3-16 Checking the Front Panel LEDsColor StateTable 3-1 Front Panel LEDs continued Removing or Replacing a Cisco Global Site Selector3-17 To physically remove a GSS 4490 from your network, follow these steps 3-18To physically replace a GSS 4490, follow these steps 3-193-20
Related manuals
Manual 94 pages 36.36 Kb Manual 92 pages 54.88 Kb