Cisco Systems 4490 appendix Connecting Power, Booting the System, 3-15

Page 15
Connecting Power

Chapter 3 Installing the Cisco Global Site Selector 4490

Connecting Power

Connecting Power

To connect power to your AC system, follow these steps:

1.Review the safety information outlined in Chapter 2, Preparing for Installation.

2.Plug the AC power cord into the power cord receptacle at the rear of the GSS 4490 (see Figure 3-9.)

3.Connect the other end of the power cord to a power source at your installation site.

4.Power up all externally connected devices.

5.Press the power control button on the front of the GSS 4490.

Booting the System

When you power up a Cisco Global Site Selector, the boot process:

Performs hardware initialization and power-on self tests

Initializes the BIOS

Initializes the Linux boot manager, LILO (Linux Loader)

Boots the GSS image (kernel and software)

Displays the startup banner and splash screen for strong encryption

Prompts you to log in to the GSS

Note While the GSS 4490 is powering up, the green power LED on the front of the GSS 4490 is on.

At this point you are ready to use the GSS device. Refer to the Cisco Global Site Selector Configuration Guide and the Cisco Global Site Selector Command Reference for details on setting up, configuring, and using the GSS device.

 

 

Cisco Global Site Selector 4490 Hardware Installation Guide

 

 

 

 

 

 

78-15755-01

 

 

3-15

 

 

 

Image 15
Contents C H A P T E R Installing the Cisco Global Site SelectorUnpacking and Inspecting the Global Site Selector Cisco Global Site Selector Hardware Installation GuideIf the Product is Damaged Tools and Parts Required83198 Figure 3-1 Four-Post Rack Installation KitInstalling Your Unit Figure 3-2 Installing Clip Nuts or Cage Nuts in a Non-Threaded Rack Installing the Chassis in a Four-Post RackSlide rail assembly Figure 3-4 Attaching the Inner Slide Rail to the GSS 2 Adjustment screw Release tab 3-10Chapter 3 Installing the Cisco Global Site Selector 3-11Installing the Chassis in a Two-Post Rack Cisco Global Site Selector 4490 Hardware Installation GuideRepeat this step to secure the left side bracket to the rack 3-123-13 Installing the Chassis on a Workbench or Tabletop3-14 Connecting CablesConnecting Power Booting the System3-15 State Checking the Front Panel LEDs3-16 ColorRemoving or Replacing a Cisco Global Site Selector 3-17Table 3-1 Front Panel LEDs continued To physically remove a GSS 4490 from your network, follow these steps 3-18To physically replace a GSS 4490, follow these steps 3-193-20
Related manuals
Manual 94 pages 36.36 Kb Manual 92 pages 54.88 Kb