Reference Information
Copying Bootable Images Between Flash Memory Cards
As future releases of Cisco IOS images become available, you will receive these images either as a netbooted file, a file on floppy disk, or a file on a Flash memory card.
The following scenario describes how to use a newly released image on a Flash memory card, in a system that has an older image on a Flash memory card in slot 0 (and a default boot image in the onboard Flash SIMM).
For this scenario, the filenames are as follows:
•
•
•
the new image on the new Flash memory card is image.new
the old image in the Flash memory card in slot 0 is image.old
the bootable image in onboard Flash memory is image.boot
You will copy the new image from the new Flash memory card onto the Flash memory card that contains the old image.
Note The scenario assumes that the new image will fit on the Flash memory card in slot 0, alongside the old image. If there is not enough available space, use the delete command to delete files from the Flash memory card to make sufficient room for the new image; however, do not delete the image.old file. Then use the squeeze command to remove these deleted files from the Flash memory card. If, after you have deleted files and used the squeeze command, the two files cannot coexist on the Flash memory card in slot 0, remove this card (place it in an
Step 1 Boot the router. By default, the file image.boot will be used.
Step 2 Enable the router as follows:
Router> en
Password:
Router#
Step 3 Insert the new Flash memory card in slot 1.
Step 4 Use the following command to copy the file image.new in slot 1, to the Flash memory card in slot 0, only if there is enough memory space for the two images to coexist. If there is not enough memory space, proceed to Step 5.
Router# copy slot1:image.new slot0:image.new
Note The previous command can also be entered as copy slot1:image.new slot0:.
7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers 45