Safety Guidelines
1 | Slide rail assemblies (2) | 2 | M3.5 screws with lock washers (3) |
|
|
|
|
3 | M4 screws (6) | 4 | M6 screws (10) |
|
|
|
|
5 | Clip nuts (10) | 6 | Cage nuts (10) |
|
|
|
|
7 | Cage nut insertion tool (1) |
|
|
|
|
|
|
Note The right and left slide rails are identical.
Safety Guidelines
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the following precautions.
Warning Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available.
Warning The safety cover is an integral part of the product. Do not operate the unit without the safety cover installed. Operating the unit without the cover in place will invalidate the safety approvals and pose a risk of fire and electrical hazards.
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning This unit is intended for installation in restricted access areas. A restricted access area is where access can only be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is controlled by the authority responsible for the location.
Warning Class 1 laser product.
Installing the Cisco Content Engine 510 and 565
10 |
| |
|