Cisco Systems 510, 565 Checking the LEDs, Indicator Color State Description

Page 20

Checking the LEDs

Step 3 Connect the other end of the power cord to a power source at your installation site.

Step 4 Power up all externally connected devices.

Step 5 Press the power control button on the front of the Content Engine.

The system should begin booting. Once the operating system boots, you are ready to initialize the basic software configuration. (Refer to the software configuration guide or user guide that shipped with your system.)

Note While the Content Engine is powering up, the green power LED (labeled 4 in Figure 11) is on.

Note You can install a circular disk over the power control button to prevent accidental manual power down. This disk, known as the power control button shield, comes with your Content Engine.

Checking the LEDs

When the Content Engine is up and running, observe the front and back panel LEDs to verify that your system is operating properly.

Figure 11 shows the location of front panel LEDs, and Table 2 describes their function.

Figure 11 Front Panel LEDs

1

2

3

4

 

 

 

 

 

83109

Table 2

Front Panel LEDs

 

 

 

Indicator

 

Color

State

Description

1

CD-ROM drive activity

Green

On

The CD-ROM drive is in use.

2

System error

Amber

On

A system error has occurred. An LED on the

 

 

 

 

 

diagnostic LED panel is also on to further

 

 

 

 

 

isolate the error.

3

Hard disk drive activity

Green

Flashing

The associated hard disk drive is in use.

4

Power

Green

On

Power is flowing to the Content Engine.

 

 

 

 

Flashing

The Content Engine is in standby mode.

Figure 12 shows the location of back panel LEDs, and Table 3 describes the LED functions.

Installing the Cisco Content Engine 510 and 565

20

78-14731-02

 

 

Image 20
Contents Documentation Survey IntroductionContents If You Need More InformationBewaar Deze Instructies Aviso Instruções Importantes DE Segurança Warnung Wichtige SicherheitshinweiseAvvertenza Importanti Istruzioni Sulla Sicurezza Guarde Estas Instrucciones Installing the Cisco Content Engine 510 78-14731-02 Description Model Product NumberContent Engine 510 and 565 Back Panel Installation Prerequisites Tools and Parts RequiredSafety Guidelines General Precautions Operating Specifications Specification DescriptionProtecting Against Electrostatic Discharge Rack-Mounting ConsiderationsSpecification Description Installing a Content Engine 510 or 565 Unit Cage nuts Clip nutsSlide rail assembly Release latch Inner slide rail Attaching the Inner Slide Rail to the Content Engine Attaching the Slide Rails to the Rack Installing the Chassis on a Tabletop Inserting the Inner Slide RailsConnecting Cables Connecting Power and Booting the SystemIndicator Color State Description Checking the LEDsIndicator Color State Back Panel LEDsState Meaning Accessing the Acns Software on the Content EngineConnecting a PC to the Content Engine Removing or Replacing a Content Engine Replacement, Repair, or Refund Policy for Hardware Cisco One-Year Limited Hardware Warranty TermsDuration of Hardware Warranty To Receive a Return Materials Authorization RMA Number Obtaining DocumentationCisco.com Documentation CD-ROMObtaining Technical Assistance Ordering DocumentationDocumentation Feedback Cisco TAC WebsiteTAC Case Priority Definitions Obtaining Additional Publications and InformationOpening a TAC Case Obtaining Additional Publications and Information