Chapter 4 Upgrading the 2.4-GHz Radio
Installing a 2.4-GHz Radio
Step 5 Insert the radio card into the access point’s
a.Tilt the radio card at approximately 20o to 30o so that its gold pins are aligned with the
b.Push the card into the
Step 6 Carefully push the card down (towards the access point’s motherboard) until the
Step 7 Carefully position the antenna wires so that the metal connectors do not touch each other.
Caution Do not allow antenna connectors to touch while power is applied, or the radio can be damaged. If they are touching, carefully rotate them in opposite directions until they are separated.
Step 8 Reinstall the
Step 9 Look at the compliance labels on your access point. Depending on the model you originally ordered, there may be up to three labels affixed to the case.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
|
| |
|