Cisco Systems 1200 manual Declaration of Conformity for RF Exposure

Appendix B Declarations of Conformity and Regulatory Information

Declaration of Conformity for RF Exposure

Note Combinations of power levels and antennas resulting in a radiated power level above 100 mW equivalent isotropic radiated power (EIRP) are considered as not compliant with the above mentioned directive and are not allowed for use within the European community and other countries that have adopted the European R&TTE directive 1999/5/EC or the CEPT recommendation Rec 70.03 or both. For more details on legal combinations of power levels and antennas, refer to the Appendix D, “Channels and Maximum Power Levels.”

For 54 Mbps, 5 GHz access points, the following standards were applied:

•	Radio:	EN 301.893
•	EMC:	EN 301.489-1, EN 301.489-17
•	Safety:	EN 60950

The following CE mark is affixed to the 54 Mbps, 5 GHz access points:

• For AIR-RM20A (not supported on the AIR-LAP1232AG-A-K9)

49325

• For AIR-RM21A and AIR-RM22A

Declaration of Conformity for RF Exposure

The radio module has been found to be compliant to the requirements set forth in CFR 47 Sections 2.1091, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices as defined in Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields. For the IEEE 802.11B antennas, AIR-ANT24120, AIR-ANT4121 and AIR-ANT1949 the equipment should be positioned more than 2 m (6.56 ft) from your body or nearby persons. For all other approved antennas the equipment should be installed more than 20 cm (7.9 in.) from your body or nearby persons.

The access point (with 5 GHz integrated antenna) must be installed to maintain a minimum 20 cm

(7.9 in.) co-located separation distance from other FCC approved indoor/outdoor antennas used with the access point. Any antennas or transmitters not approved by the FCC cannot be co-located with the access point antennas. The access point’s co-located 2.4 GHz (2.2 dBi) and 5 GHz integrated antennas support a minimum separation distance of 10 cm (3.9 in.) and are compliant with the applicable FCC RF exposure limit when transmitting simultaneously.

Note Dual antennas used for diversity operation are not considered co-located.

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-8370-04 B-7