Inserting PC Cards

L i f e B o o k A 6 0 0 0 S e r i e s N o t e b o o k - S e c t i o n F o u r

PC Card

PC Card Eject Button

PC Card Slot (lower slot only)

Figure 4-7. inserting/Removing PC Card

PC Cards/ExpressCards™

Your LifeBook notebook supports Type I and Type II PC Cards and ExpressCardsTM, which can perform a variety of functions depending on which type of card you insert. You can insert one or two cards at a time, depending on its type. PC Cards should be inserted in the bottom slot, and ExpressCards in the top slot.

Some available PC/ExpressCards:

■Wireless WAN cards

■IDE solid-state disk cards (Type II)

■SCSI cards (Type II)

For further information, refer to the instructions supplied with your card(s).

PC Cards are inserted in the PC Card slot (the lower of the two slots). To insert a PC Card, follow these steps:

■Inserting or removing a PC Card during your LifeBook notebook’s shutdown or bootup process may damage the card and/or your LifeBook notebook.

■Do not insert a PC Card into a slot if there is water or any substance on the card as you may permanently damage the card, your notebook, or both.

You may be required to log on as an Administrator or member of the Adminis- trator’s Group to complete this procedure. If the computer is connected to a network, network policy settings may also prevent you from completing this procedure.

1.See your PC Card manual for instructions on the insertion of your card. Some cards may require that your notebook is off while inserting them.

2.Make sure there is no PC Card currently in the slot. If there is, see Removing PC Cards.

3.If the eject button is extended, press it until it clicks.

4.Insert the card into the slot with the label facing up.

5.Push the card firmly into the slot until it is seated in the connector.

REMOVING PC CARDS

See your PC Card manual for specific instructions on removing your card. Some cards may require your note- book to be in Sleep Mode or Off during removal.

■Windows has a shutdown procedure for PC Cards that must be followed before removing a card. (Review your operating system manual for the correct proce- dure.) It is good practice to remove devices using the Safely Remove Hard- ware icon in the Notification Area at the bottom right of the display.

■If the dialog box states that the device cannot be removed, you must save all of your open files, close any open applica- tions and shut down your notebook.

1.Unlock the card from the slot by pressing the eject button associated with the slot in which the card is located. When pressed, the button will pop out.

2.Firmly press the button again until it is flush with the notebook. This will eject the card slightly out of the slot allowing you to remove the card.

If the PC Card has an external connector and cable, do not pull the cable when removing the card.