Configuring the Cisco 12008
Configuring Global Parameters
When you first enter the setup facility or issue the setup command, you are queried by the system to configure global parameters for your router.
To boot the system and establish global configuration parameters, perform the following steps:
Step 1 Connect a console terminal to the console port on the RP.
Step 2 Boot the system to display the user EXEC prompt (Router>).
After about 30 seconds, the following display appears on the console, indicating that you have successfully booted the system:
System Bootstrap, Version 11.2(8)GS [biff 571], RELEASED SOFTWARE
Copyright (c)
Restricted Rights Legend
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph
(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec.
(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec.
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, California
Cisco Internetwork Operating System Software
IOS (tm) GS Software
Copyright (c)
Compiled Mon
Image
Cisco 12008/GRP (R5000) processor (revision 0x00) with 65536K bytes of memory.
Processor board ID 00000000
R5000 processor, Implementation 35, Revision 2.1 (512KB Level 2
Cache)
Last reset from
1 clock scheduler card(s)
3 switch fabric card(s)