Configuring the Cisco 12008
Repeat Step 2 or Step 3, as required, to individually configure each port on every Quad
If you have an ATM line card installed in your router, proceed with Step 4; otherwise, skip to Step 5.
Step 4 Configure the ATM line card interface(s).
Asynchronous Transfer Mode (ATM) interfaces enable connections to external
In the following example, an ATM line card is being configured to use IP. Respond to the configuration dialog, as appropriate for your configuration. Use your address and subnet mask for the setup prompts.
Configuring interface parameters:
Configuring interface ATM1/0:
Is this interface in use?: yes
Configure IP on this interface?: yes
IP address for this interface: 1.1.1.2
Number of bits in subnet field: 0
Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0
Note You might have to establish additional configuration parameters for the installed ATM line cards if you want to fully utilize them. The new parameters would be used in such activities as the configuring of permanent virtual circuits (PVCs).
For more complete configuration information for ATM line cards, refer to the document entitled
Repeat Step 4 for each installed ATM line card. To display and verify the ATM line card configuration parameters, proceed with Step 5.
Observing System Startup and Performing a Basic Configuration