Reinstalling Components in the Router
In standard EIA and
•The pattern of holes at the top of the left and the right router mounting flanges should match at least two holes in each of the two mounting posts.
•The pattern of holes at the bottom of the left and the right router mounting flanges should match at least two holes in each of the two mounting posts.
Thus, to properly secure the router to the mounting posts in a
Step 7 Secure the router to the mounting posts using the screws provided in the accessories box.
Reinstalling Components in the Router
This section presents the procedures for reinstalling the components removed from the router in preparation for rack mounting the chassis.
Reinstalling the Cards in the Upper Card Cage
Before attempting to reinstall the cards in the upper card cage, refer to the notes you made when you depopulated the upper card cage (see Step 3 in the section entitled “Removing Cards from the Upper Card Cage”).
To replace a card in the upper card cage, perform the following steps:
Step 1 Attach an antistatic ESD wrist strap to your wrist; ensure that it makes good contact with your skin.
Step 2 Insert the equipment end of the wrist strap (the banana jack) into the ESD connection socket near the lower left corner of the upper card cage. Figure
Step 3 Select the top card from the antistatic mat. It is assumed that you will reinstall the cards in the upper card cage in reverse order. That is, the top card that you placed earlier on the antistatic mat should be the first card to be reinstalled in the router (see Step 6 in the section entitled “Removing Cards from the Upper Card Cage”).