Cisco Systems 8540 CSR, 8510 CSR appendix 5CB

Chapter 4 Configuring Interfaces

Configuring the ATM Uplink Interface (Catalyst 8540)

Example

The following example shows sample output for the show interfaces atm command.

Router# show interfaces atm 0/0/0 ATM0/0/0 is down, line protocol is down

Hardware is epif_port_garfield, address is 0090.2157.c407 (bia 0090.2157.c407) MTU 4470 bytes, sub MTU 4470, BW 155000 Kbit, DLY 10 usec, rely 0/255, load 1/

255

Encapsulation ATM, loopback not set, keepalive not supported Full-duplex, Unknown Speed

ARP type: ARPA, ARP Timeout 04:00:00

Encapsulation(s): AAL5 AAL3/4, PVC mode

8191 maximum active VCs, 1024 VCs per VP, 0 current VCCs VC idle disconnect time: 300 seconds

Last input never, output never, output hang never Last clearing of "show interface" counters never Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 8 packets output, 2736 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

Example

The following example shows sample output for the show controllers atm command.

Router# show controllers atm 0/0/0
slot: 0/0		Controller-Type :XPIF ATM				OC3 PM - 1 Port SM_IR
0000	chan0		chan1 chan2 chan3 sstr 1200
task0	11		11	11	11
task1	5CB		5CB	5CB	5CB
task2	11		11	11	11
task3	5CB		5CB	5CB	5CB
SMDR 0xFF78			SSTR 0x1200 SSMR 0x4002 EVER 0x3001
SIMR 0x0000			MBXW 0x0000 MBXR 0x0000 SPER 0xF000
TX SAR (Beta 2.1.2) is Operational;
RX SAR (Beta 2.1.2) is Operational;
SAR Counters:
	tx_paks			5, tx_abort_paks				0, tx_idle_cells		48482684
	rx_paks			5, rx_drop_paks				0, rx_discard_cells			0
Xpif Counters:
	MR1	580		MR2	0	MR3	5	MR4	0	MR5	0
	MR6	0		MR7	0	MR8	0	MR9	0	MR10 0
	MR11	0		MR12	0	MR13	5	MR14 0		MR15 0
	MR16	0		MR17	0	MR18	0	MR19 0		MR20 0
	MR21	0
	SR1	2500		SR2	598	SR3	0	SR4	0	SR5	0
	MT1	560		MT2	0	MT3	5	MT4	0	MT5	0
	MT6	0		MT7	0	MT8	0	MT9	0
	ST1	0		ST2	0
	MRXS	131188		MTXS	112	SRXS 3		STXS 0

	Layer 3 Switching Software Feature and Configuration Guide
78-6235-04, Cisco IOS Release 12.0(10)W5(18)		4-37