Cisco Systems 8510 CSR, 8540 CSR Monitoring Snooping, Show snoop interface, Destination-port

Chapter 4 Configuring Interfaces

Monitoring Snooping

Monitoring Snooping

To monitor the current snooping mode configuration and status, use the following commands:

Command	Purpose
show snoop interface	Displays whether the indicated destination port is in snooping
destination-port	mode. If so, it indicates the source (monitored) port and the
	snooping direction.
show snoop	Displays all the snoop sessions configured on the system.
show snoop-vc interface	Displays the list of virtual circuits that are being monitored by the
destination-port	destination port.

Now that you have configured the interfaces on your switch router, see Chapter 5, “Configuring Networking Protocols,” for instructions on configuring network and routing protocols.

	Layer 3 Switching Software Feature and Configuration Guide
78-6235-04, Cisco IOS Release 12.0(10)W5(18)		4-41