Cisco Systems 7200 VXR manual Cisco 7204VXR Router-Front View

Chapter 1 Cisco 7200 VXR Product Overview

Cisco 7204VXR Overview

With the NPE-G1 or NPE-G2 installed and the Port Adapter Jacket Card installed in the I/O controller slot, an additional port adapter slot is available.

Note If you have difficulty installing a processing engine or I/O controller in the lowest slot of a Cisco 7200 VXR router that is rack-mounted, remove the port adapters, processing engine and I/O controller from the chassis and reinstall them. Install the processing engine and I/O controller in the lowest slots first, then populate the slots above them, in a bottom-to-top order.

Figure 1-1 Cisco 7204VXR Router—Front View

1

2

3

3

1

															Cisco 7200 SERIES XVR
									ETHERNET 10BT									FAST ETHERNET
										ENABLED				MII	LINK	RJ45				4
														0
								SERIAL-EIA/TIA-232										ETHERNET-10BFL
EN										EN	TX	RX	TX	RX	TX	RX	TX	RX	TX	2
	1	2	3	4	5	6		7		RX
0											0		1	2			3	4
						SLOT	1		MII						FAST ETHERNET INPUT/OUTPUT CONTROLLER
								FE
ENABLED																				0
	PCMCIA			EJECT	SLOT						LINK
									EN	EN
						0			MII	RJ45	RJ45
																				15889
4									5					6				7

1	Port adapters	5	Optional Fast Ethernet interface (MII port and
			RJ-45 port)
2	Port adapter lever	6	Auxiliary port
3	I/O controller	7	Console port
4	PC Card slots

Note In Figure 1-1, a blank port adapter is installed in slot 3. To ensure adequate airflow across the port adapters, each port adapter slot must be filled with either a port adapter or a blank port adapter.

The rear of the Cisco 7204VXR router provides access to the network processing engine or network services engine and up to two power supplies. (See Figure 1-2.)

Cisco 7200 VXR Installation and Configuration Guide

OL-5013-08 1-5