Cisco Systems 805 manual Where to Go Next, Verifying Installation Normal

Verifying Installation

Verifying Installation

Verify the power, Ethernet, and serial connections by checking the LEDs. Table 2-3describes the normal pattern for each LED and what to do if you get an abnormal pattern.

Table 2-3 Verifying Installation

	Normal
LED	Pattern Explanation	If Abnormal Pattern

OK	On	Power is supplied to the
		router. Router completes
		self-test procedure and
		begins operating.

If off, refer to Chapter 3, “Troubleshooting.”

LINK	On	(LINK LED is located on
		router back panel.)
		Ethernet device is connected.

If off, toggle the HUB/NO HUB button (if set to HUB [in], reset to NO HUB [out] or vice versa).1 If still off, refer to Chapter 3, “Troubleshooting.”

CD	On	Serial interface is up, and
(Carrier		carrier signal is detected.2
detect)

If off for a long time, refer to Chapter 3, “Troubleshooting.”

1For information on how the setting of the router HUB/NO HUB button might be affected by the setting of an equivalent hub button, see the “Connecting an Ethernet Device” section earlier in this chapter.

2You must configure the serial interface before this LED turns on. For more information on configuring the serial interface, see the Cyclone 805 Router Software Configuration Guide.

Where to Go Next

You have completed the hardware installation and are ready to configure the software. Cisco strongly recommends that you use the Cisco 805 Fast Step software. Use the Cisco 805 Fast Step CD-ROM that ships with the Cisco 805 router and Cisco 805 Fast Step online help. If you decide to use the command-line interface (CLI) to configure the software, refer to the Cisco 805 Router Software Configuration Guide.

Installing the Cisco 805 Router 2-17