Cisco Systems AIRCAP2602IAK9 specifications

Page 13

Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate Cisco wireless LAN controller guide.

a.Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management and AP-Manager Interface.

b.Configure the switch to which your access point is to attach. See the Cisco Unified Wireless Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional information.

c.Set the Cisco wireless LAN controller as the master so that new access points always join with it.

d.Make sure DHCP is enabled on the network. The access point must receive its IP address through DHCP.

e.CAPWAP UDP ports must not be blocked in the network.

f.The access point must be able to find the IP address of the controller. This can be accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP method to convey the controller IP address. For other methods, refer to the product documentation. See also the “Using DHCP Option 43” section on page 16 for more information.

Step 2 Apply power to the access point:

a.The access point is 802.3af (15.4 W) compliant and can be powered by any of the following 802.3af compliant devices:

–WS-C3550, WS-C3560, and WS-C3750 switches

–C1880 switch

–2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms

–2610XM, 2611XM, 2621XM, 2650XM, 2651XM, and 2691 multiservice platforms

–2811, 2821, and 2851 integrated services routers

–3620, 3631-telco, 3640, and 3660 multiservice platforms

–3725 and 3745 multiservice access routers

–3825 and 3845 integrated services routers

The recommended external power supply for the access point is the Cisco AIR-PWR-B power supply. The access point can also be powered by the following optional external power sources:

–1250 series access point power injector (AIR-PWRINJ4)

–Any 802.3af compliant power injector

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Cisco Aironet 2600 Series Access Points About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement Unpacking ConfigurationsExternal Antennas Regulatory Domains Internal AntennasCountries Supported Access Point Ports and Connections top Access Point Ports and ConnectorsAccess Point LED Indicator top Controller Discovery Process Configuring the Access PointPage Installation Summary Preparing the Access PointPre-Installation Configuration Setup Performing a Pre-Installation ConfigurationPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointUsing Dhcp Option TroubleshootingChecking the Access Point LED LED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information Models Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsConfiguring Dhcp Option 43 and Dhcp Option Add the option 60 line using the following syntax Access Point SpecificationsObtaining Documentation and Submitting a Service Request 78-20842-01
Related manuals
Manual 38 pages 43.83 Kb
Top Page Image Contents