Cisco Systems AIRCAP2602IAK9 specifications

Page 14

Note The 2600 series access point requires a Gigibit Ethernet link to prevent the Ethernet port from becoming a bottleneck for traffic because wireless traffic speeds exceed transmit speeds of a 10/100 Ethernet port.

b.As the access point attempts to connect to the controller, the LEDs cycle through a green, red, and amber sequence, which can take up to 5 minutes.

Note If the access point remains in this mode for more than five minutes, the access point is unable to find the Master Cisco wireless LAN controller. Check the connection between the access point and the Cisco wireless LAN controller and be sure that they are on the same subnet.

c.If the access point shuts down, check the power source.

d.After the access point finds the Cisco wireless LAN controller, it attempts to download the new operating system code if the access point code version differs from the Cisco wireless LAN controller code version. While this is happening, the Status LED blinks dark blue.

e.If the operating system download is successful, the access point reboots.

Step 3 Configure the access point if required. Use the controller CLI, controller GUI, or Cisco WCS to customize the access-point-specific 802.11n network settings.

Step 4 If the pre-installation configuration is successful, the Status LED is green indicating normal operation. Disconnect the access point and mount it at the location at which you intend to deploy it on the wireless network.

Step 5 If your access point does not indicate normal operation, turn it off and repeat the pre-installation configuration.

Note When you are installing a Layer 3 access point on a different subnet than the Cisco wireless LAN controller, be sure that a DHCP server is reachable from the subnet on which you will be installing the access point, and that the subnet has a route back to the Cisco wireless LAN controller. Also be sure that the route back to the Cisco wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP communications. Ensure that the route back to the primary, secondary, and tertiary wireless LAN controller allows IP packet fragments. Finally, be sure that if address translation is used, that the access point and the Cisco wireless LAN controller have

astatic 1-to-1 NAT to an outside address. (Port Address Translation is not supported.)

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Cisco Aironet 2600 Series Access Points Introduction to the Access Point About this GuideSafety Instructions Important Safety Instructions20A. Statement External Antennas ConfigurationsUnpacking Countries Supported Internal AntennasRegulatory Domains Access Point Ports and Connectors Access Point Ports and Connections topAccess Point LED Indicator top Configuring the Access Point Controller Discovery ProcessPage Preparing the Access Point Installation SummaryPerforming a Pre-Installation Configuration Pre-Installation Configuration SetupPage Page Mounting the Access Point Deploying the Access Point on the Wireless NetworkChecking the Access Point LED TroubleshootingUsing Dhcp Option LED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information Models Vcci Statement for Japan 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry CanadaModels Page Page Declaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Declaration of Conformity Statements Portuguese TranslationConfiguring Dhcp Option 43 and Dhcp Option Access Point Specifications Add the option 60 line using the following syntaxObtaining Documentation and Submitting a Service Request 78-20842-01
Related manuals
Manual 38 pages 43.83 Kb
Top Page Image Contents