Cisco Systems AIRCAP2602IAK9 specifications Models

Page 21

Models

Certification Numbers

AIR-CAP2602E-A-K9LDK102080

AIR-CAP2602I-A-K9

AIR-SAP2602E-A-K9

AIR-SAP2602I-A-K9

Manufacturer:

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

This device operates in the 5150-5250MHz and 5470-5725MHz bands and is therefore restricted to indoor operation only per FCC guidance.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase separation between the equipment and receiver.

•Connect the equipment to an outlet on a circuit different from which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician.

Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could void the user’s authority to operate this device.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Cisco Aironet 2600 Series Access Points About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement Configurations UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported Access Point Ports and Connections top Access Point Ports and ConnectorsAccess Point LED Indicator top Controller Discovery Process Configuring the Access PointPage Installation Summary Preparing the Access PointPre-Installation Configuration Setup Performing a Pre-Installation ConfigurationPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointTroubleshooting Using Dhcp OptionChecking the Access Point LED LED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information Models Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsConfiguring Dhcp Option 43 and Dhcp Option Add the option 60 line using the following syntax Access Point SpecificationsObtaining Documentation and Submitting a Service Request 78-20842-01
Related manuals
Manual 38 pages 43.83 Kb
Top Page Image Contents