Cisco Systems AIRCAP2602IAK9 specifications Preparing the Access Point, Installation Summary

Page 11

Preparing the Access Point

Before you mount and deploy your access point, we recommend that you perform a site survey (or use the site planning tool) to determine the best location to install your access point.

You should have the following information about your wireless network available:

Access point locations.

Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a desktop.

Note You can mount the access point above a suspended ceiling but you must purchase additional mounting hardware: See “Mounting the Access Point” section on page 15 for additional information.

Access point power options: power supplied by the recommended external power supply (Cisco AIR-PWR-B), a DC power supply, PoE from a network device, or a PoE power injector/hub (usually located in a wiring closet).

Note Access points mounted in a building’s environmental airspace must be powered using PoE to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses from each location and return them to the person who is planning or managing your wireless network.

Installation Summary

Installing the access point involves these operations:

Performing a pre-installation configuration (optional)

Mounting the access point

Grounding the access point

Deploying the access point on the wireless network

11

Image 11
Contents Cisco Aironet 2600 Series Access Points About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement External Antennas ConfigurationsUnpacking Countries Supported Internal AntennasRegulatory Domains Access Point Ports and Connections top Access Point Ports and ConnectorsAccess Point LED Indicator top Controller Discovery Process Configuring the Access PointPage Installation Summary Preparing the Access PointPre-Installation Configuration Setup Performing a Pre-Installation ConfigurationPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointChecking the Access Point LED TroubleshootingUsing Dhcp Option LED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information Models Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsConfiguring Dhcp Option 43 and Dhcp Option Add the option 60 line using the following syntax Access Point SpecificationsObtaining Documentation and Submitting a Service Request 78-20842-01
Related manuals
Manual 38 pages 43.83 Kb